Double BTS7960 43A High-Power IBT2 Motor Drivers System Electronics Board Module DIY Smart Car Semiconductor Cooler For Arduino ESP32

説明

製品紹介：

This product is a high-power motor drive module. One module can only connect the motor forward and reverse. Multiple modules can drive multi-phase motors.

Dual BTS7960 high current (43A) H-bridge driver

Isolated from 5V of MCU, effectively protects MCU

Can realize forward and reverse rotation

PWM speed regulation, PWM input maximum frequency 25KHZ

Overcurrent, short circuit, overvoltage, overheat protection

Isolated from MCU, protects MCU

 

製品パラメータ：

Input voltage: 6-27V

Output current: maximum 43A

Input level: 3.3V-5V

Control mode: PWM control, duty cycle 0-100%

Overvoltage protection value: 30V

Overcurrent protection value: 84A

Overheat protection value: 200°C

Rated power: within 200W

 

Pin description:

VCC: 3.3V-5V input, provides control signal level voltage GND: ground terminal

R_IS: forward current alarm output. Please refer to BTS7960 datasheet for this function

L_IS: reverse current alarm output. Please refer to the BTS7960 datasheet for this function

R_EN: forward drive enable input, high level enable, low level disable

L_EN: reverse drive enable input, high level enable, low level disable

RPWM: rotation control signal input, please see the truth table below

LPWM: rotation control signal input, please see the truth table below

B+: connect to the positive pole of the power supply, 6-27V

B-: connect to the negative pole of the power supply

M+: connect to the motor

M-: connect to the motor

 

Instructions for use:

Wiring diagram

If you use the module to drive the DC motor, you can refer to the above diagram for wiring. As for the single-chip program, you can write it yourself. If you are using the Arduino development board, it will be very simple. Arduino provides development libraries and sample programs for this driver board. The current alarm pin is not connected in the figure. You need to check the BTS7960 data sheet. The data sheet contains instructions for the use of this pin.

 

予防：

1. Pay attention to the wiring diagram and do not make a mistake.

2. This document only represents the product knowledge and parameters at the time of editing. If you have purchase needs, you can contact this store to inquire about the latest situation.Thanks.

製品のカスタマイズ

当社は製品のカスタマイズサービスを提供しています。. お問い合わせ お客様のご要望について話し合うため。.