LM2596 Convertidor reductor de CC a CC, regulador de voltaje, pantalla LED, voltímetro, adaptador reductor de 4,0~40 a 1,3-37 V, fuente de alimentación ajustable

Descripción

Voltage regulator chip: LM2596S-DJ

Equipped with reverse connection protection, overheating protection, and short circuit protection

Input voltage: DC4.0-40V

Output voltage: DC1.25-37V continuously adjustable

Output current: maximum 3A

Output power: Maximum 10W (5V/2A)

Trinity 0.36-inch red digital tube

Equipped with an input/output voltage indicator light that can be switched by pressing a button to display the input/output voltage

Can turn off or on the digital display with one click

Equipped with terminal blocks and reserved welding points for easy wiring

Digital tube calibration method:

The calibration value range is -0.5~0.5, the factory parameter is 0, the unit is V, and the voltage value of one unit is 0.02V. Positive numbers indicate upward calibration, and negative numbers indicate downward calibration.

1. Input voltage calibration method: After the module is powered on, let the digital display show the input voltage. At this time, the “IN” indicator light is always on. Press and hold the button for 2 seconds and then release it. At this time, the digital display flashes. Adjust the calibration value by pressing the button. After adjustment, press and hold the button for 2 seconds to exit the calibration mode and save the set parameters. It will not be lost when power is off;

2. Calibration method for output terminal voltage: After the module is powered on, let the digital tube display the output voltage. At this time, the “OUT” indicator light is always on. Press and hold the button for 2 seconds and then release it. At this time, the digital tube flashes. Adjust the calibration value by pressing the button. After adjustment, press and hold the button for 2 seconds to exit the calibration mode and save the set parameters. It will not be lost in case of power failure.

Atención:

For the first use, the potentiometer should be rotated counterclockwise for more than ten turns before adjusting the voltage.

2. The peak output current is 3A, and it should work within 2A for a long time. If it exceeds 2A, it is necessary to strengthen heat dissipation.

3. This module is a voltage reduction module, with an output voltage lower than the input voltage and a voltage difference of at least 1V.

4. The maximum output voltage and maximum output current cannot be met simultaneously, and the maximum output power of 10W is the limiting condition. Output voltage * output current=output power.

5. Do not use load voltage regulation. Adjust the parameters first, then connect the load circuit, and finally connect the power.

6. Do not use high voltage, high current, or hot swapping to prevent damage to the module.

When the input voltage is below 4V, the digital display will not display or work. To ensure the accuracy of the voltmeter display, the input voltage must be above 4.5V.

Personalización de productos

Ofrecemos servicios de personalización de productos. Contáctanos para hablar de sus necesidades.