Leonardo R3マイクロコントローラーATmega32u4開発ボード（USBケーブル付き）Arduino DIYスターターキット対応

説明

Arduino Leonardo is a microcontroller board based on ATmega32u4. It has 20 digital input/output pins (7 for PWM output and 12 for analog input), a 16 MHz crystal oscillator, a Micro USB interface, a DC interface, an ICSP interface, and a reset button.

Leonardo is different from all previous Arduino controllers in that he directly uses the USB communication function of the ATmega32u4 and eliminates the USB to UART chip. This allows Leonardo to not only serve as a virtual (CDC) serial/COM port, but also connect to a computer as a mouse or keyboard.

製品パラメータ：

Microcontroller ATmega32u4

Working voltage 5V

Input voltage DC 7V-12V

Digital I/O pin 20

PWM channel 7

Analog input channel 12

Each I/O has a DC output capacity of 40mA

3.3V port output capacity 50mA

Flash 32 KB (ATmega32u4), of which 4 KB are used by the bootloader

SRAM     2.5 KB（ATmega32u4）

EEPROM    1 KB（ATmega32u4）

Clock speed 16MHz

Special attention:

If it is lower than 7V, the 5V pin will provide power less than 5V, and the control board may be unstable. If a power regulator greater than 12V is used, it may overheat. Reduce hot swapping and try not to carry loads, which may damage the circuit board.

製品のカスタマイズ

当社は製品のカスタマイズサービスを提供しています。. お問い合わせ お客様のご要望について話し合うため。.